Hoover QS Quiet - Manual (Page 10)

To connect and
remove tools
To connect the tools, insert end of
tool into the extension wand and
snap into position. To disconnect,
press down on the center of the
spring latch and remove tool.
Tools may also be attached to the
handle by rotating the plastic latch
ring to accept the button projec-
tion on the tool. Then, turn the
latch ring as shown to lock the
tool in place.
To remove the tool, reverse the
above procedure.
The power cord leading from the
hose connection to the receptacle
on the cleaner base need not be
connected when using the clean-
ing tools.
However, to avoid
damage to the cord, leave
cord connected to the recept-
acle on the cleaner.
To clean hard to
reach areas
The tools attached to the curved
wand, as shown, will enable you
to clean many hard to reach areas;
especially crown moldings, tops
of drapery rods, shelves, and pic-
ture frames.