Hoshizaki KM-1601MRH/3 - Manual (Page 24)

24
26) Remove the rubber cap covering the overflow pipe in the water tank. Remove the
overflow pipe by turning it counterclockwise. Drain the water tank. Replace the overflow
pipe, the rubber cap and the insulation panel in their correct positions.
Note: Do not replace the insulation panel when you proceed to "2. Sanitizing
Procedure."
27) Repeat the above steps 15) through 26) three more times to rinse thoroughly.
Note: If you do not sanitize the icemaker, go to step 9) in "2. Sanitizing
Procedure."
2. Sanitizing Procedure - Following Cleaning Procedure
1) Dilute 2.5 fl. oz. (74 ml or 5 tbs) of a 5.25% sodium hypochlorite solution (chlorine
bleach) with 5 gal. (19 l) of warm water.
2) Pour the sanitizing solution into the water tank.
3) Replace the insulation panel and the front panel in their correct positions.
Note: Make sure that the control switch is in the "WASH" position and the cleaning valve
is open.
4) Turn on the power supply, and start the sanitizing process.
5) Turn off the power supply after 15 minutes.
6) Remove the front panel, and then remove the insulation panel by first lifting the top
panel and sliding the top panel to the back a little.
7) Remove the rubber cap covering the overflow pipe in the water tank. Remove the
overflow pipe by turning it counterclockwise. Drain the water tank. Replace the overflow
pipe, the rubber cap and the insulation panel in their correct positions.
8) Repeat the above steps 15) through 26) in "1. Cleaning Procedure" two times to rinse
thoroughly.
9) Close the cleaning valve.
10) Move the control switch to the "ICE" position.
11) Replace the front panel in its correct position.
12) Clean the storage bin with water.
13) Turn on the power supply, and start the automatic icemaking process.