Humax ND-1200C - Manual (Page 12)

Safety
11
1. STANDBY LED
Red light is emitted when the product is in STANDBY mode.
While watching the analog Fee-To-Air Channels, the Set-Top Box should be in the
STANDBY mode.
2. SMART CARD SLOT
Slot for a smart card.
The Smart Card is to be placed in the slot with the red arrow “Insert card this way up”
facing upwards (i.e. Chip-side downwards).
NOTE: THE CARD IS TO BE INSERTED GENTLY TILL IT STOPS AND REMAINS
APPROX. 1 CM OUTSIDE.
1.2 Front Panel
1 2
1. CABLE IN
Connect the incoming Cable-TV signal to the CABLE IN jack on the Set-Top Box.
2. CABLE OUT
Connect the outgoing cable from CABLE OUT to the TV set.
3. AUDIO R/L
Connect the AUDIO R to the TV AUDIO IN and AUDIO L to the TV AUDIO IN using
RCA-RCA cord.
4. VIDEO
Connect the VIDEO to your VIDEO IN of TV / VCR using RCA-RCA cord.
1.3 Rear Panel
1 2 3 4