Harman Stove Company Harman Gas 929BV User Manual

Page 6

The.front.is.released.when.

levers.on.the.left.and.

right.sides.are.pushed.to.

the.rear

asseMblY

The.Clarity.is.shipped.from.the.factory.with.the.log.set.

packed inside the firebox. To prepare the stove for installa-

tion,.the.log.set.must.be.unpacked,.the.appropriate.burner.

system.module.for.either.natural.gas.or.propane.installed,.

and.the.logs.installed.
Removing the Glass Front

NOTE:.The.glass.front.is.heavy..Be.prepared.for.its.

weight.when.lifting.it.to.avoid.damage.during.removal.

The.wing.doors.on.each.side.are.held.closed.by.magnets..

Push.on.each.door.to.open.it..Loosen.the.wing.nut.on.each.

of.the.two.levers..Grasp.each.lever.and.push.to.the.rear.to.

disengage.the.front..To.keep.the.levers.in.the.disengaged.

position,.tighten.the.wing.nuts..Lift.the.glass.front.slightly.

and.remove.it.from.the.stove..Set.the.glass.aside.in.a.safe.

place.where.it.will.not.be.damaged.

WaRnInG: Do not abuse the Clarity's glass by

striking, slamming, or similar trauma. Do not oper-

ate the Clarity Vented Gas Heater with the glass panel

removed,

cracked or broken. Use only glass supplied by Harman

and approved for use with this heater. Do not use substi-

tute materials. Replacement of the panel should be done

by a licensed or qualified service person.
Remove and Unwrap the Log Set

As.shown.in.the.photo.above.right,.the.log.set.consists.

of.a.back.log.(1),.a.center.log.that.has.a.pilot-viewing.port.

in.the.left.end.(2),.ember.strip.(3),.and.a.branch.that.rests.on.

top.(4)..

In.addition,.there.are.two.side.brick.panels.and.a.back.

brick.panel.

The. log. set. components. are. shipped. from. the. factory..

individually.wrapped.and.packed.inside.the.stove..Take.them.

out.of.the.stove,.then.carefully.remove.the.wrapping..Handle.

the.logs.gently.as.they.may.be.damaged.easily.