HP WP36/50 - Manual (Page 91)

Chapter 5 Maintenance
5-3
Remove the seal from the rear of the old waste toner
box, and then close the opening of the box with the
seal. Seal up the old waste toner box with the sup-
plied plastic bag and dispose of it.
Figure 5-11
Gently pull the cleaning knob as far as it will go, push
and pull it several times, and then push it back in.
Figure 5-12
Take out the new grid cleaner from the protective
bag, and then remove the cap from the grid cleaner.
Figure 5-13
Pull the main charger approximately 5 cm (2 inches)
out.
Figure 5-14
While avoiding the main charger roller (A) to be in
contact with the grid cleaner pad, push and pull the
main charger several times. (Do not push the main
charger all the way in. Otherwise, water from the
pad will cause the main charger unit to become we
and this may affect printing.)
Figure 5-15
When the grid is clean, remove the grid cleaner from
the printer and dispose of it. The grid cleaner is not
re-usable.
Fit the new waste toner box to the printer.
Figure 5-16
10
11
12
13
14
(A)
15