Hayter Mowers 405607x52A User Manual

Page 12

F-050743L

Storage (over 30 days)

At the end of each year, prepare the unit for stor-

age as follows.
1. Drain the fuel from the carburettor and the

fuel tank. Change the engine oil. See the en-

gine manufacturer’s instructions.

2. Clean the entyre unit.
3. Charge the battery.

How To Order Replacement Parts

The replacement parts are shown either on the

back pages of this Instruction Book or in a sep-

arate Parts List Book.
Use only manufacturer’s authorized or approved

replacement parts. The letter placed on the end

of the part number denotes the type of finish for

the part, C for chrome, Z for zinc, a PA for pur-

chased assembly. It is important that you include

this when ordering a part. Do not use attach-

ments or accessories not specifically recom-

mended for this unit. In order to obtain proper

replacement parts you must supply the model

number of your mower (see nameplate).
Replacement parts, except for the engine, trans-

mission, transaxle or differential, are available

from the store where the mower was purchased

or a service shop recommended by the store.
If you are unable to obtain parts or service in the

manner outlined above, then contact:

HAYTER LIMITED,

Service Department,

Spellbrook,

Bishop’s Stortford,

Hertfordshire. CM23 4BU.

MURRAY, INC.

International Sales

P.O. Box 268

Brentwood, Tennessee USA 37024

1-800-251-8007

Fax (615) 373-6633 Collect telephone calls will

not be accepted.
Replacement parts for the engine, transaxle, or

transmission, are available from the manufac-

turer’s authorized service centre found in the

commercial pages of the telephone directory.

Also, see the individual engine or transmission

warranties to order replacement parts.
When ordering the following information is re-

quired:

(1) The Model Number

(2) Serial Number

(3) Part Number

(4) Quantity