Honeywell WSK-24 - Manual (Page 5)

INSTALLATION WSK-24 WIRELESS OCCUPANCY SOLUTION
5 62-0300ES—01
Fig. 6. Door sensor bracket mounting.
4. Make sure the notched side of the door sensor is
pointing in the direction that you will mount the
magnet. See Fig. 7 and Fig. 8.
Fig. 7. Door sensor tab notches.
5. Snap the sensor in place.
6. Align one end of the magnet with the notched side
of the door sensor housing.
7. Mount the magnet a maximum of 3/4 in. (19 mm)
from the door sensor, as illustrated in Fig. 8.
Fig. 8. Maximum distance between door sensor and
magnet.
8. Secure the magnet to the door by using the two
screws or adhesive tape provided. An optional
spacer is provided, as well. See Fig. 9.
Fig. 9. Door magnet mounting options.
9. Open and close the door to ensure that there is no
interference.
CHECK THE DOOR SENSOR FUNCTION
1. Open the door and verify that the LED on the door
sensor flashes three times when the contact is
opened.
2. Close the door and verify that the LED on the door
sensor flashes another three times.
Mounting the PIR Occupancy Motion Sensor
Fig. 10. PIR occupancy motion sensor mounting
options.
1. Take off the cover by removing the cover release
screw on the bottom of the PIR back plate.
2. Power the PIR sensor by inserting the three AAA
batteries provided. See Fig. 12 for proper battery
orientation.
3. Secure the PIR sensor to the wall using one of the
following three options
M29153
SCREWS TO
HOLD BRACKET
MOUNTING
BRACKET
TAB TO RELEASE
DOOR SENSOR
ADHESIVE
TAPE
M29154
TAB
NOTCHES
TAB
NOTCHES
TAB
NOTCHES
MUST FACE
THE MAGNET
M29155
1 MAXIMUM DISTANCE BETWEEN SENSOR AND
MAGNET 3/4 (19).
1
M29156
SCREWS TO
MAGNET OR
SPACER
ADHESIVE
TAPE
OPTIONAL
SPACER
M29157
COVER
SCREWS
TO HOLD
SENSOR
PIR BACK
PLATE
ADHESIVE
TAPE
SCREWS
TO FIX THE
BRACKET
PLASTIC
CONICAL
ANCHORS
MOUNTING
BRACKET
SCREW TO
RELEASE
COVER