Honeywell RAPID EYE K5404V9 - Manual (Page 80)

View: Operator Guide
6–16
Table 15
Event default settings for log and alarm
source event log alar
m
View operator Session: connect, reject and
disconnect nil nil
Maintenance: configuration, security,
system files, synchronize time, clear
storage, clear stream “ “
Outputs: activate, deactivate* “ “
Multi-Media unit System: run-time failure, self-restart,
reboot, no video recording, time
server unusable, no synchronization
in 24 hours, excessive system clock
drift, SMART disk failure log by default “
outside world Inputs: activate, deactivate nil “
Video: signal unlock, signal unlock “ “
Motion: Not on Event tab; on the
Video tab. “ “
customer-device user defined: Not on Event tab; on
the Serial Devices tab. “ “
* Control Output 6 is unavailable as an event when Fault Relay is enabled. The Control
Outputs on a Multi-Media LT unit remain available when its Fault Relay is enabled.