Quickspecs – HP ProLiant ML115 G5 User Manual
Page 25
Interface
SATA
Access Times (typical)
Random
<100 ms
Full-Stroke
<150 ms
Data Transfer Rate
Sustained
3000 to 7200 KB/s (20X to 48X)
Burst
150 KBps to 7,200 KBps
Bus Rate
1.5Gbps
Cache Buffer
128 KB
Start-up Time (typical)
< 7 seconds
Stop Time
< 4 seconds
Laser Parameters
Type
Semiconductor Laser GaA1As
Wave Length
780 ± 25 nm
Operating Conditions
Temperature
41° to 122° F (5° to 50° C)
Humidity
10% to 90%
Dimensions
(HxWxD, maximum)
1.63 x 5.75 x 7.87 in (41.3 x 146 x 195 mm)
Weight
2.64 lb (1.2 kg)
4 port Embedded SATA
controller
SATA Protocol
SATA 2, 3Gb/s
SATA Ports
4 internal
Port transfer rate
1.5 Gb/s total
Maximum Capacity
up to 3.0TB (4 x 750GB non-hot plug SATA HDD)
RAID Levels Supported RAID 1+0 (Striping & Mirroring)
RAID 1 (Mirroring)
RAID 0 (Striping)
RAID 5 (Striping with parity)
Logical RAID Volumes
Supported
NOTE: On SATA models with embedded RAID, setup instructions are
located in User Guide, CTO RAID is set-up is not available. HP ProLiant
100 Series Server User Guide:
Embedded NC105i PCIe
Gigabit Server Adapter
Network Interface
10Base-T/100Base-TX/1000Base-TX
Compatibility
IEEE 802.3 10Base-T
IEEE 802.3ab 1000Base-T
IEEE 802.3u 100Base-TX
Data Transfer Method
Single lane (x1), 100MHz PCI Express Reference Clock
Network Transfer Rate 10Base-T (Half-Duplex)
10 Mb/s
10Base-T (Full-Duplex)
20 Mb/s
100Base-TX (Half-
Duplex)
100 Mb/s
100Base-TX (Full-
Duplex)
200 Mb/s
1000Base-TX (Half and
Full-Duplex)
2000Mb/s
Connector
RJ-45 connector
Cable Support
10Base-T
Categories 3, 4 or 5 UTP; up to 328 ft (100 m)
10/100/1000Base-TX
Category 5 UTP; up to 328 ft (100 m)
QuickSpecs
HP ProLiant ML115 Generation 5
Technical Specifications
DA - 13013 Worldwide QuickSpecs — Version 10 — 12.15.2008
Page 25