Hotpoint WD71 - Manual (Page 7)

4. Connect to a Drainage
System...
● Do not remove hooked end support from drainage hose.
● Do not position standpipe near an electrical outlet.
● For drainage into a standard work top sink ensure outlet pipe has a
minimum bore of 32 mm. To avoid syphoning ensure the end of the
drainage hose is above the water level in the sink. If your sink is inset, the
front edge of the basin must be less than 75 mm from the front edge of
your work top.
We recommend one of the following
drainage methods:-
Standpipe
Note: Ensure the standpipe has a
minimum diameter of 38 mm.
1. Ensure top of standpipe is positioned
at least 500 mm from the floor (Fig 1).
2. Untie the end of the GREY drainage
hose from the rear of the appliance
and place approximately 100 mm into
the standpipe.
3. If the end of GREY drainage hose is
fitted with ‘Retaining Flaps’, ensure
that they are fully inserted into the
standpipe as shown (Fig 2).
Sink Waste System
Note: Ensure the sink outlet pipe has a
minimum diameter of 32 mm.
1. Untie the end of the GREY drainage
from the rear of the appliance.
2. Reposition ‘Hooked End Support’ as
required along GREY drainage hose.
3. If fitting an under sink waste disposal
unit (Fig 3), cut out the membrane,
bung or blanking plug (Fig 4 and 4a).
4. Attach the GREY drainage hose to
the under sink waste disposal unit
securely, using a Jubilee clip.
5. Raise the hose to a minimum height
of 800 mm to avoid syphoning.
5. Adjust the Feet...
This must
only be done when the machine is upright
● Release locking rings on the two front feet.
● Screw feet in or out until appliance is
standing firm and level.
● Ensure all feet are in firm contact with the
floor and the machine is not leaning forward.
● Tighten the locking rings on the front feet to the underside of the cabinet.
Note: Your appliance may become noisy or move about the floor if it has
not been stabilised.
When you have installed your
appliance, ensure it is ready to use by
following this 10 Step Check List
1. Dispose of packaging safely,
see ‘Recycling Information’
on page 3.
2. Position appliance close to
electrical/water supply see
‘Location’ on page 4.
3. Remove transit brackets, screws
and spacers see ‘Remove
Transit Brackets’ on page 5.
4. Connect supplied hoses to
appliance water supply, confirm
water is flowing before connecting
to the appliance inlet valves
see ‘Water Supply’ on page 6.
5. Untie drainage hose at rear of
appliance and connect to either
a standpipe or sink waste drainage
system see ‘Drainage’ opposite.
6. Untie mains lead at rear of
appliance and plug into
electrical supply via a switched
socket, see ‘Electrical Supply’ on
page 2.
7. Position appliance, taking care
not to kink or damage hoses
at rear of appliance.
8. Stabilise the appliance, see
‘Adjusting the feet’ opposite.
9. Turn on the water supply
to the appliance.
10. Switch on at plug socket.
500 mm
Fig 1
Fig 3
Fig 2
Fig 4 - Before Fig 4a - After
Your appliance is now ready to use,
refer to ‘Getting to Know your
Appliance’ on page 8 to familiarise
yourself with the appliance.
10 Step 10 Step
Check List Check List
7