Remove transit brackets – Hotpoint WD71 User Manual

Page 5

WARNINGS

● Before using appliance,

remove transit brackets,

clamps and screws

Retain parts for future

transportation.

Replace work top lid and 3

screws.

Remove 3 screws and front

transit bracket, retain.

Remove 4 screws and rear

transit bracket, retain.

From rear of appliance, grip

sides of work top lid, lift, slide

and pull towards you.

Slide and push work top lid into

position, ensuring front edge is

correctly located into console.

Remove 3 screws from back of

work top lid, retain.

Fig 2

Fig 1

Remember you may be

charged for a service call

if a problem with your

appliance is caused by

incorrect installation or

misuse.

2. Remove Transit Brackets...

Your appliance is fitted with internal transit brackets (Fig 1) which prevents damage to the

appliance during transit. Remove parts (Fig 2) following the instructions below.

Note: It is normal for the door seal to look creased, it will not affect its use.

Front Transit Bracket

Rear Transit Bracket

● After removing the

packaging from the

machine, ensure that

the polystyrene pyra-

mid (shown below) has

come away from the

underside of the

machine, with the

polystyrene base.

If it has not come away,

remove it by tilting the

machine backwards until

the pyramid can be seen

and then remove.