Hotpoint WD71 - Manual (Page 21)

21
Error Messages...
If at anytime the following error messages are displayed in the Infobubble™ please follow our
recommendations before calling a Service Engineer.
Error Code Problem Recommendation
No hot/cold fill. Check the water supply, inlet
valve and hot and cold hose
connections (see ‘Connect to the
Water Supply’ on page 6).
A fault with the water heating Call for a Service Engineer.
has occurred.
Water is not being pumped out Check the drainage hose is
and a flood condition could occur. raised to the recommended
minimum height and that it is
not blocked (see ‘Connect to a
Drainage System’ on page 7).
If it still not working, call for a
Service Engineer.
Extremely high water level. Disconnect or turn off the water
supply and ensure that the water
level does not rise anymore.
Call for a Service Engineer.
Door not closed properly (see ‘Interlocking Door System’
on page 9).
A motor drive problem has Try running the programme again.
occurred. If the problem persists call for a
Service Engineer.
Customer language and wash Call for a Service Engineer to
programme have not been re-program your appliance.
saved,system will run with default
conditions (1000rpm max and
English language).
E10
E11
E13
E14
E15
E16
E17
E30
E31
E50
E51