Hotpoint WD71 - Manual (Page 16)

16
Cancel Button
To start the selection again, press and hold the cancel button for a few seconds, all settings
displayed will disappear and the Infobubble™ will display ‘Select Programme’.
Note: If pressed when setting ‘Time Delay’ or when time delay is active, time delay is
cancelled but the selected wash programme and optional wash features will remain, the
Infobubble™ will display these. Press start to proceed with the programme.
Drying Prog./Drying Time
● Not available with programme ‘F’.
Press Button Action Infobubble™ Display
x 1 Selects low heat programme.
x 2 Selects full heat programme.
Note: To increase drying time by 10 minute increments up to 120 minutes, press
and hold button.
Start, Buzzer/Time Delay
Press Button Action Infobubble™ Display
x 1 & Hold Buzzer - Lets you know when the programme has
finished or when Rinse Hold is activated.
Time Delay - Gives you the option to delay your wash
programme from 1 to 18 hours.
Note: When the button is released the programme will start automatically and the
Infobubble™ will display ‘Starting Programme’.
Variable Rinse
● Not available with programme ‘F’.
Press Button Action Infobubble™ Display
x 1 Add a rinse for sensitive skin
x 2 Delete a rinse to save time and water
x 3 Return to normal programme setting
Variable Spin
Press Button Action Infobubble™ Display
x 1 Display existing programme spin speed.
x 2 & Hold Reduce spin speed by 100rpm intervals
to 400rpm or ‘0’ (no spin).
x 3 Return to normal programme setting.
Variable Temp.
Press Button Action Infobubble™ Display
x 1 & Hold Reduce programmed temperature in 5 C intervals
to a minimum of 30 C
x 2 Cancel