Pre-assembly, Assembly step 1, Warning – Horizon Fitness DT680 User Manual

Page 8

INTRODUCTION

IMPORT

ANT

PRECAUTIONS

ASSEMBL

BEFORE

YOU
BEGIN

TREADMILL

OPERA

TION

LIMITED

ARRANTY

TROUBLESHOOTING

MAINTENANCE

CONDITIONING

GUIDELINES

DO NOT CUT STRAPS UNTIL STEP 1-E!*

Disassemble box and remove the

cardboard packaging that is not beneath the treadmill. Do not attempt to lift the

treadmill at this time. Remove plastic wrap from console masts.

NOTE:

During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before

completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware.

Any grease, such as lithium bike grease is recommended.

Open HARDWARE BAG 1.

Lift LEFT CONSOLE MAST into

upright position. Be sure to hold

the console mast firmly, as it

will not stay in the upright

position on it’s own.

Move LEFT SIDE LINKAGE ARM

into position. Insert BOLT (A)

and tighten.

Repeat on the right side.

Now cut the banding straps and

remove remaining packaging

material.*

Lift the RUNNING DECK until

lock latch on side of treadmill

is fully engaged.

Remove CONSOLE from box

and place out of the way.

Lower the treadmill RUNNING

DECK from the folded position

by stepping on LOCK LATCH on

lower right side.

PRE-ASSEMBLY

WARNING

ASSEMBLY STEP 1

#0-5 "
NN
2UZ

HARDWARE BAG 1 CONTENTS :

-&'5$0/40-&."45

-&'54*%&-*/,"(&"3.

#0-5"

* NOTE: If the straps have been removed before completing step 1-D and the linkage arms can not be aligned,

refer to the TROUBLESHOOTING section (page 26) in order to restore the treadmill to its proper position.