Hitachi VT-MX431A - Manual (Page 60)

HINTS FOR TIMER RECORDING
60
HINTS FOR TIMER RECORDING
· If there is a power failure or the VCR is unplugged for more than 30 seconds, the clock
setting and all timer settings will be lost.
· If the tape runs out before the end time, the VCR will switch to the Stop mode immediately,
eject the tape and the VCR power will be turned off. The " " indicator will flash.
· If a tape is not inserted or the erase-protection tab is removed, the " " indicator flashes and
timer recording cannot occur. Please inset a recordable tape.
· The TV that is connected to your VCR may be turned ON or OFF when the VCR is in the
timer-record mode.
CORRECTING AN AUTOMATIC TIMER PROGRAM
1) Turn the power on.
2) Repeat steps [1] to [3] on page 24.
3) Go to the digit you want to change by using the F.FWD/ button or REW/ button.
4) Enter correct numbers by using the PLAY/
or STOP/ button.
5) Press the RESET/EXIT button to return to original mode.
6) Press the POWER button to return to timer stand-by mode.
STOPPING A STARTED AUTOMATIC TIMER PROGRAM
Press the STOP/EJECT button on the VCR.
NOTE: The STOP button on the remote control will not function in Automatic Timer Recording
mode.
CANCELING OR CHECKING THE START/END TIME
1) Turn the power on.
2) Press the MENU button.
3) Select a program number you want to check by using the PLAY/
or STOP/ button. The
details of selected program appears on the TV screen.
You may cancel the entire program by pressing the REW/ button.
4) Press the RESET/EXIT button to return to original mode.