haier DW-7777-01 User Manual

Page 26

English

chEck opERATIoN

1. Read the Use and Care Guard included with your dishwasher.
2. Check that all parts have been installed and no steps were skipped. Check

that you have all the tools you used.

3. At fuse box or circuit breaker, turn on electrical power supply to dishwasher.

Start dishwasher and allow it to complete the shortest wash cycle. after

the first two minutes, unlatch door, wait five

seconds, then open door. Check to see that

there is water in the bottom of the dishwasher

and that there are no water leaks.

4. Check that grounding clip “a” is attached to

the lower panel. Place the lower panel “b”

behind the access panel “C”. Some models

have insulation “D” on the access panel which

must fall behind the insulation “E” on the lower

panel. hold the two panels together and place

them against dishwasher leg.

Reinstall the screws through the holes in the

access panel and the slots in the lower panel.

Install right side screw first. Check that the

lower edge of the lower panel contacts the

floor. Tighten the screws.

If dishwasher does not operate:
• Has the circuit breaker tripped or the house fuse blown?
• Is the door closed tightly and latched?
• Has the cycle been set correctly to start the dishwasher?
• Is the water turned on?