haier DW-7777-01 User Manual

Page 13

English

hElpful TIp:

Wiring the dishwasher will be easier if you route wire

into the cabinet opening from the left side.

3. DIREcT WIRE mEThoD:

Cut a 3/4” (1.9cm) hole ”C” in right hand cabinet side,

rear or floor. Optional locations are shown. Wood

Cabinet: Sand hole until smooth.

3a. poWER supplY coRD mEThoD:

Cut a 11/2”(3.8cm) hole “D”in right-hand cabinet rear

or side. Optional locations are shown. Wood cabinet:Sand hole until smooth.

Run wire into house wiring junction box. Use strain relief method provided

with junction box. If no strain relief is provided, install

a UL-listed/CSA-certified clamp connector for flexible-

type wire. If installing conduit, attach a UL-listed/CSA-

certified conduit connector to junction box.

4a.

Install a mating, three-prong, grounding-

type wall receptable “E”in the cabinet next to the

dishwasher opening. Go to step 6.

Run other end of wire through cabinet hole.

Cable must extend to the left front of cabinet

opening. Go to step 6.
Install a mating, three-prong, grounding-type wall

receptacle “E”in the cabinet next to the dishwasher

opening. Go to step 6.

WATER lINE

Cut a 1/2”(1.3 cm) minimum hole “F” in left-hand

cabinet side,rear or floor. Optional locations are shown.

(The hole “F” is about 1-3/5” higher than hole “C” or

hole “D”)

Measure total length of copper tubing “G” required.

attach copper tubing to water line with manual shut-

off valve. Carefully feed copper tubing through hole in

cabinet (copper tubing will bend and kink easily) until

it is far enough into the cabinet opening to connect it to

dishwasher inlet on the front left of dishwasher.

hElpful TIp:

Routing the water line through the left side of

cabinet opening will make water connection easier.