haier DW-7777-01 - Manual (Page 21)

English
20
WARNING
Electrical shock hazard
Electrically ground dishwasher. Connect ground wire to
green ground connector in terminal box. Do not use
an extension cord. Failure to ground dishwasher can
result in death, fire, or electrical shock.
1. Install strain relief and route direct wire so that it does not
touch dishwasher motor or lower part of dishwasher tub. Pull
direct wire “A” through hole in terminal box.
hElpful TIp:
Select the proper size twist-on connectors to connect your
household wiring to 16-gauge dishwasher wiring.
Insert wire ends into twist-on connector. Do not pre-twist
bare wire. Twist connector. Gently tug on wires to be
sure both are secured.
2. Connect the wire “b” as follows using twist-on
connectors “C” sized to connect direct wire to
16-gauge dishwasher wire:
from bare ground wire “D” into a U-shaped hook.
Wrap ground wire hook clock- wise around ground
connector “E” and under the washer “f”. Securely
tighten ground connector “E” and under the washer
“f”. Securely tighten ground connector “E”. Do not untie knot in the wires.
3. Tighten clamp connector or conduit connector screws “G”.
4. Reinstall terminal box cover “H” with wires inside
terminal box. Go to step 5. The cover must be outside the
box on the right side. Make sure no wires are pinched by
cover. Do not leave the box without the cover.
DIREcT WIRE mEThoD
A
G
Black