HP QM2-101 - Manual (Page 5)

4
MSSC, LLC Collinsville, IL USA Tel: 618-343-1006 Fax: 618-343-1016 55899 Rev 18210
www.msscllc.com
4a. Mount the QM2 to the bracketry.
•
Place the base clamp on the bottom of the QM2 over the end of the vertical tubing and tighten to secure the print head.
•
Adjust the print head by loosening the cross clamp with a 5/32” or 4 mm allen wrench.
•
The QM2 should be perpendicular to the product. If the print head is angled print quality will suffer.
•
Once the QM2 is in position tighten all screws on the clamps
4c. Connect the print head data cable.
(For QM2-111 only)
CAUTION: Never connect or disconnect the
data cable with the QM2 powered on. Doing so
may damage the printer and void the warranty.
Connect the data cable to the print head and
controller. Tighten the screw locks and route the
cable in such a way as to avoid items that might
cause damage to it.
4b. Mount the remote print head.
(For QM2-111 only)
Mount the Remote print head using M5 screws
extending into the print head no more than 6 mm.
Note: Print head bracketry kit is sold separately.
(MSSC P/N 55325)