Hayes Microcomputer Products DIVA T/A ISDN - Manual (Page 60)

DIVA T/A ISDN Modem User’s Guide 60
Using the VT100 Configuration Tool
The section below describes how to configure your DIVA T/A under
DOS and OS/2.
The VT100 Configuration Tool is incorporated in the DIVA T/A
firmware. Use it to configure basic ISDN-specific parameters.
Note: AO/DI is not supported on the DOS/OS/2 VT100 configuration
tool. To configure AO/DI, you should use the AO/DI AT commands
as described in the Reference Guide.
Activating the VT100 Configuration Tool
To activate the VT100 Configuration tool:
1 Start the VT100-compatible terminal-emulation program. Set up
your VT100 terminal-emulation program (for example, Telix or
HyperAccess), using the table below as a guideline:
Parameter Setting
Terminal Emulation Type VT100/VT102
Local Echo Off
CR Translation CR
LF after CR Off
2 Verify that the terminal-emulation program uses the same COM
port as that assigned to the DIVA T/A.