Husqvarna 305 - Manual (Page 62)

62 - English
9. TROUBLE SHOOTING
9.3 Symptom
If your Automower ® does not work as expected, follow the troubleshooting guide below.
There is a FAQ (Frequently Asked Questions) on www.automower.com which provides more detailed
answers to a number of standard questions. It you still cannot find the reason for the fault, contact the local
dealer.
Symptom Cause Action
The robotic lawn
mower has difficulty
docking with the
charging station The boundary wire is not laid in a long
straight line that is far enough out from
the charging station. Check that the charging station has
been installed according to the
instructions in 3.2 Installation of the
charging station on page 16.
The guide wire is not inserted in the
slot at the bottom of the charging
station. It is absolutely critical for operation
that the guide wire be perfectly straight
and is in the correct position under the
charging station. Therefore make sure
that the guide wire is always in its slot
in the charging station. See
3.6 Installation of the guide wire.
The charging station is on a slope Place the charging station on a
surface that is completely level. See
3.2 Installation of the charging station
on page 16.
Uneven mowing
results Automower ® works too few hours per
day.
Increase the mowing time, see
6.3 Timer (1) on page 43.
The proportion setting is incorrect in
relation to the layout of the working
area Check that the correct Proportion
value is selected. See 6.4 Installation
(2) on page 44.
Working area too large. Try limiting the working area or
extending the working time, see
6.3 Timer (1) on page 43.
Dull blades. Replace all the blades and screws so
that the rotating parts are balanced.
See 8.7 Blades on page 56.
Long grass in relation to the set cutting
height. Increase the cutting height and then
successively lower.
Accumulation of grass by the blade
disc or around the motor shaft. Check that the blade disc rotates
freely and easily. If not, screw off the
blade disc and remove grass and
foreign objects. See 8.4 Cleaning
Automower ® runs at
the wrong time
The clock on Automower ® needs to be
set.
Set the clock, see 6.6 Settings (4) on
page 49.
The start and stop times for mowing
are incorrect. Reset the start time and stop time
settings for mowing, see 6.3 Timer (1)
on page 43.