Husqvarna 305 - Manual (Page 22)

22 - English
3. INSTALLATION
Boundaries for the working area
If a high obstacle, for example a wall or fence,
borders the working area, the boundary wire should
be laid 12" (30 cm) from the obstacle. This will
prevent Automower
® from colliding with the obstacle
and reduce body wear.
About 8” (20 cm) around the fixed obstacle will not be
mown.
If the working area borders against a small ditch, for
example, a flower bed or a small elevation, e.g. a low
verge (1" - 2"/3 - 5 cm), the boundary wire should be
laid 8" (20 cm) inside the working area. This prevents
the wheels from driving into the ditch or up onto the
verge.
About 5” (12 cm) of grass along the ditch/stone
edging will not be mown.
If the working area borders against a flat path or the
like that lies level with the lawn, it is possible to allow
Automower
® to run a little over the path. The
boundary wire should then be laid 2" (5 cm) from the
edge of the path.
All the grass along the side of the pavement will be
cut.
When the working area is divided by a flat slab path
that is level with the lawn, it is possible to allow
Automower
® to run over the path. It can be an
advantage to lay the boundary wire under the slabs.
The boundary wire can also be laid in the joint
between the slabs.
Note! The Automower ® must never run over gravel,
mulch or similar material which can damage the
blades.
IMPORTANT INFORMATION
If the working area is adjacent to water
bodies, slopes, precipices or a public road,
the boundary wire must be supplemented
with a fence or something similar. The height
must then be at least 6" (15 cm). This will
prevent Automower
® from ending up outside
the working area under any circumstances.
Min.
15cm