HP 5400c Series - Manual (Page 110)

110 Using software commands and controls Back to TOC
Using keyboard shortcuts and the
menus
This section summarizes the menus and commands in the
HP Precisionscan Pro software that you can select using the
keyboard. To open a menu, press
A LT + the underlined letter for that
menu. To perform a command, open the menu and press the
underlined letter for that command.
This section also shows which commands can be performed using a
keyboard accelerator (shortcut).
Note: The Guided Steps are available for computers running
Internet Explorer version 4.0 or greater. See "Resolving
issues that did not generate messages" on page 87 .
New Scan C TRL + N Start (preview) a new scan.
Scan To... C TRL + T Scan and send to a destination, such as
e-mail.
Scan to CD Save scanned photos or documents on a
CD-writer drive.
Return Image to... When using TWAIN, return the scanned
image to the other program.
Save As... C TRL + S Save the selection area as a file.
Print C TRL + P Scan and print the selection area.
Print Setup Change printing options.
Scanner Glass
XPA (Slides)
XPA (Negatives) Select the source from which to scan. Only
one can be selected.
Settings
Save Save settings.
Load Load (use) settings.
Preferences Change scanning default preferences.
Exit A LT + F4 Close the HP Precisionscan Pro software.
Scan
Reset Tools C TRL + Z Return all settings except output type to
the defaults for this image.
Copy C TRL + C Scan and place the selection area on
the Clipboard.
Select All C TRL + A Select the entire scanner glass
(including blank space).
Unselect All E SC Remove the selection border.
Zoom In Zoom in on the selection area.
Zoom Out Zoom out to the original view.
Guided Steps Show or hide the Guided Steps.
Tool Bar Show or hide the toolbar.
Info Bar Show or hide the Info bar.
Status Bar Show or hide the Status bar.
Edit
View