Hoshizaki F-330BAH(-C) User Manual
Page 14
14
5. Sanitizing Procedure - Final
1) Remove the front panel.
2) Move the control switch to the "DRAIN" position to drain the remainder of the solution.
3) After the solution has drained, move the power switch to the "OFF" position and unplug
the unit.
4) Remove the top panel.
5) Remove the bin control assembly from the top insulation and set it aside. Remove the
top insulation.
6) Remove the thumbscrews attaching spout (B) to the bin, then remove spout (B).
7) Remove the thumbscrews attaching spout (A) to the evaporator assembly, then remove
spout (A).
8) Pour the sanitizing solution over the extruding head until the evaporator assembly and
the reservoir are filled and the solution starts to overflow into the drain pan.
9) Allow the icemaker to sit for about 10 minutes before operation.
10) Replace all parts in their correct positions.
11) Plug the unit back in. Move the control switch to the "ICE" position and move the power
switch to the "ON" position. Replace the panels in their correct positions and allow the
unit to make ice using the solution until it stops automatically.
12) Remove the front panel.
13) Move the control switch to the "DRAIN" position to drain the remainder of the solution.
14) After the solution has drained, move the control switch to the "ICE" position.
15) Replace the front panel in its correct position.
16) Open the water supply line shut-off valve to supply water to the reservoir.
17) When the gear motor starts, remove the front panel and move the control switch to the
"DRAIN" position to drain out the water from the icemaker.
18) After the water has drained, move the control switch to the "ICE" position and allow the
icemaker to run. Replace the front panel in its correct position.
19) After 30 minutes, remove the front panel and move the power switch to the "OFF"
position. Unplug the unit.
20) Pour warm water into the storage bin to melt all ice, then clean the bin liner with the
solution.
21) Rinse out any solution from the storage bin.
22) Plug the unit back in. Move the power switch to the "ON" position to start the automatic
icemaking process.
23) Replace the front panel in its correct position.