Hoshizaki F-330BAH(-C) - Manual (Page 12)

12
6) Lift up the top insulation and unsnap the bin control assembly. Lift the assembly up
through the insulation and set it aside. See Fig. 3.
7) Remove the top insulation.
Spout (B)
Thumbscrew
Fig. 4
Evaporator Assembly
Spout
Packing (A)
Cylinder Packing
Extruding Head
Spout (A)
Thumbscrew
Top Insulation
Bin Control
Assembly
Fig. 3
8) Remove the thumbscrews attaching spout (B) to the bin, then remove spout (B). See
Fig. 4.
9) Remove the thumbscrews attaching spout (A) to the evaporator assembly, then remove
spout (A).
10) Pour the cleaning solution over the extruding head until the evaporator assembly and
the reservoir are full and the solution starts to overflow into the drain pan.
Note: If there is excess scale on the extruding head, fill the evaporator assembly and
reservoir as described above, then use a clamp on the reservoir hose between
the reservoir and evaporator assembly to block flow. Pour additional cleaning fluid
over the extruding head until the evaporator assembly is completely full.
11) Allow the icemaker to sit for about 10 minutes before operation. If you placed a clamp on
the reservoir hose in step 10, remove it before operation.
12) Replace all parts in their correct positions.