beautypg.com

Buffer clear command, Back space commands, Skip-over perforation commands – Epson 420i User Manual

Page 53

background image

Buffer Clear Command

52. (18)H (24)D, (98)H (152)D

This code deletes the print data that has already been input. However, the control

codes are still valid.

Back Space Commands

53. (08)H (08)D, (88)H (136)D

This code prints the contents of the buffer. The printing initiation position is moved
to the left by a single character width, determined by the present character width

setting. This code is ignored in proportional print mode.

5 4 .

(1B, 3D)H (27, 61)D (Epson mode only)

In the Epson Printer mode, this code sets the eighth data bit to 0.

55.

(1B, 3E)H (27, 62)D

(Epson mode only)

In the Epson Printer mode, this code sets the eighth data bit to 1.

56.

(Epson mode only)

(1B, 23)H (27, 35)D

In the Epson Printer mode, this command cancels control of the eighth data bit set
by either the set eighth-bit or clear eighth-bit command.

Skip-Over Perforation Commands

57. (1B, 4E, n)H (27, 78, n)D, (9B, CE, n)H (155, 206, n)D

This code sets skip-over perforation line-feed mode. The n is set in line units. A form
feed to the top of the next page is automatically performed when the remaining lines

on the present page is less than n.

Setting DIP SW2-3 allows the selection of a 1 -inch skip-over perforation mode. This
command has priority over the DIP switch setting.

58. (1B, 4F)H (27, 79)D, (9B, CF)H (155, 207)D

This code terminates the skip-over perforation mode.

47