EnGenius Technologies ESR-9710 - Manual (Page 7)

ESR-9710 Wireless N Gigabit Router Version 1.0
7
1.4 Wireless SOHO Router Description
WAN WAN
LAN: 4*RJ45 LAN: 4*RJ45
10/100/1000M 10/100/1000M
DC JACK DC JACK SMA SMA
SMA SMA
SMA SMA
WAN WAN
LAN: 4*RJ45 LAN: 4*RJ45
10/100/1000M 10/100/1000M
DC JACK DC JACK SMA SMA
SMA SMA
SMA SMA
Step Label Description
1 LAN Ports (1 – 4) Use an Ethernet cable to connect each port to a computer
on your Local Area Network (LAN).
2 WAN Port Use an Ethernet cable to connect this port to your WAN
router.
3 DC Connector Use the power cable and connect the adapter to the power
socket on the wall, and the DC inlet into the DC connector.
4 Antenna Connector Connect the three antennas to the SMA connectors.
Connection / Activity
LED
This LED will light up once an Ethernet cable is connected
to one of the LAN ports.
WAN LED This LED will light up once an Ethernet cable is connected
to WAN (Internet) port.
WLAN LED This LED will light up once the RF (wireless LAN) feature is
enabled
Power LED This LED will light up once the power cable is connected to
the DC connector.
Reset Button Use this button to reset the device. You can restore the
device back to its factory default settings by holding down
on this button for 5 seconds.
WPS WPS (Wireless Push Button) is used for WiFi Protected
Setup. By pressing this button, the security settings of the
LAN Ports (1-4)
WAN Port DC Connector
LAN 1- 4 LED Power LED
Rear Panel
Front Panel
WLAN LED WAN LED
Antenna
Connector Antenna
Connector Antenna
Connector
Reset Button WPS Button