Elation Professional 1400E - Manual (Page 33)

Design Wash 1400E™
©Elation Professional® 33 Design Wash 1400E™
position.
10.5.5 Reset Others: This function will reset all other motors to the home position.
10.6 EFFECT ADJUST:
10.6.1 Test Channel – This menu function allows the user to select each individual fixture
channel and test it’s function independently from the control board.
10.6.2 Manual control – This function readies the fixture for lamp optimization in a simple
single step procedure. This function will center the pan and tilt motors while at the
same time open the shutter and bring the dimmer to 100%. The pan and tilt function
will still operate if the fixture needs to be positioned to a flat clear surface.
10.6.3 Calibrate values – This function should only be performed by a qualified technician.
This function allows a user to make small adjustments to the effect wheels (color,
gobo, shutter, etc) to compensate for ware or in the event a sensor has been knocked
slightly out of place. Because improper use of this function can result in undesired
operation this function has been password protected. The password is 050 and must
be entered each time the calibration menu function is entered.
10.7 USER MODE:
10.7.1 User mode – This function allows the user to create user defined channel orders
allowing the fixture to match the channel order of other fixtures on the market for
easier operation. A total of three user modes may be configured: User Mode A, User
Mode B, and User Mode C.
User mode
With this function, you can create user defined channel orders.
Preset User mode
This function allows the user to make the actual changes in the user-defined modes
that are accessed through the previous function.