Epson GT-5500 - Manual (Page 16)

Plugging In the Scanner
1. Make sure that the scanner is turned off. It is off when the
OPERATE button protrudes from the surface of the front
panel.
2. Connect the power cable to the power inlet on the rear of the
scanner and plug the other end into a properly grounded
outlet.
c
Caution:
It is not possible to change the scanner’s voltage. If the
label on the back of the scanner does not show the correct
voltage for your country, contact your dealer.
OPERATE
RESET
08
0 1 2 3 4 5 6 7
*
ON SW
SCSI
SCSI
04
L
GT-5500 Rev.C
A5 size Chapter 1
July-18-97 Pass 0, DR
1-4 Setting Up the Scanner