Elite Screens 052611AS - Manual (Page 10)

10
Rev.052611‐AS
www.elitescreens.com [email protected]
1. Locate your desired installation height, draw the Datum Line and mark the drill‐hole area of the
Mid‐Point. Note: The center of the hole must align with the Datum Line.
2. Mark the drill‐hole area of the L‐Point and the R‐Point. The top of the bracket must align with the
Datum Line.
3. Drill a hole with the proper bit size according to the included Wood Screws (F).
4. Line up the brackets with the drilled holes on the installation location and screw then in using a
Phillips screwdriver.
5. Position the fixed frame screen onto the Y‐Bracket (D) and push down at the center of the bottom
frame to secure the insertion of the frame into the Y‐Bracket.
6. Combine the 1.77” L‐Bracket (B) with the installed mounted 3.54” L‐Bracket (C) using the Butterfly
Screws (K) and then position frame onto the bracket.
Note: Step 6 only refers to models 125w and above. Models 85w‐115w use four 1.77” L‐Brackets (B).
7. The brackets provide flexibility by allowing the fixed frame screen to slide to the slides. This is an
important feature as it allows your screen to be properly centered.