EnGenius Technologies SN-920 - Manual (Page 16)

~ 26~
Voice Volume
Placing a Call On-Hold
Adjusting the volume on the handset can be done only during a
call or when in the TALK Mode.
* When in the TALK Mode, the volume control button on the left
side of the handset can be used to adjust the volume to 6
different levels.
* Volume level 3 is set as default.
* The top button increases volume and the lower button
decreases volume.
* The screen during volume adjustment
displays the following:
1. When a call is in progress it can be
put on hold by pressing the LEFT
SOFT FUNCTION key which selects
the HOLD option:
The display will then show:
2. To bring the call back on line, press
the LEFT SOFT FUNCTION key again.
The display will return to this screen:
The handset will double beep three times every 30
seconds when a call is on hold as a reminder that you
VOLUME: 5
REDIAL MEMORY
VOLUME: 5
HOLD MUTE
00:00:55
00:00:00
Base 1 on Hold
UNHOLD MENU
00:00:55
VOLUME: 5
HOLD MUTE
~ 25~
:
The first handset to answer a call will connect to the base
unit and will operate in TALK mode. Other registered
handsets will be locked out of the call. However they will
still be able to participate in handset to handset calls or
receive the call if transferred.
NOTE
While an incoming telephone call is ringing the handset, the
SILENT soft button feature can be selected to silence the ring
without answering or hanging up on the caller. The call will remain
on the handset until answered by another handset or the caller
hangs up. The call can be answered, while in the silent mode, by
pressing the TALK button.
SILENT feature
Caller ID service must be ordered from your local phone
company for these screen displays to function. Services may
vary in your area.
**
Handset in Charging Cradle
Handset not in Charging Cradle
Pick-up handset from charging cradle to answer the call.
Press "TALK", or any dialing key to accept the
incoming call. "2-WAY",