EnGenius Technologies SN-920 - Manual (Page 15)

~ 23~
* The following screen will appear:
* Enter the 2 digit Phone Directory
index code (e.g. 1= 01)for the stored
phone number.
* The phone number stored in the
location will be dialed.
NOTE: Telephone numbers stored in the Phone Directory
have been indexed with a number from 01 to 30. To access
the correct index number or location, follow these steps:
For example, if the location is 3, press 0 then 3.
If the index number is 12, press 1 then 2.
Answering Calls
All handsets that have been registered for use with the base unit,
and are in the IDLE mode, will ring when an incoming call is
received. The handset can be set to either ring or vibrate with an
incoming call.
NOTE: Under SETTINGS, the user has the option of
receiving incoming/intercom/transferred calls from 1 to 4
base units. This option is accessed via the Call Manager
function, under SETTING. Depending upon number of
base units the handset is registered to.
~ 24~
Receiving an incoming call
without Caller ID service
Receiving an incoming call with Caller ID
service **
* Handset LCD shows:
* Handset is off the cradle-No
caller ID service
Incoming Call
On Base 1
SILENT
* Caller ID service, but the ID has
been blocked by the caller:
* Caller ID service, but not supported
by the originating party:
* Caller ID service, but only the
number has been transmitted:
* Caller ID service, all information
has been transmitted:
Private Name
Private #
SILENT
Unknown Name
Unknown
SILENT
Private Name
555-1212
SILENT
Hayter, S
555-1212
SILENT