EnGenius Technologies SN-920 - Manual (Page 13)

~ 19~
* Do not register your handset if it has been registered at the
factory. If, when you first turn on the phone, "00" is displayed
near the top center of the LCD (to the right of the icon),
the handset has not been registered at the factory.
* Specific instructions on how to register the handset are
covered in detail under Handset / Base Registration in the
Advanced Operations section.
* If the handset is not registered
with the base unit, any attempt
to make an outgoing call or
intercom call to another handset
will fail. The LCD will read:
REGISTRATION MODE
CRADLE MODE
* Placing the handset into the charger
cradle activates the handset CRADLE
mode.
* While in the CRADLE mode, the battery
charging unit recharges the handset
battery pack.
* An incoming or intercom call while
in the CRADLE mode will generate
this screen:
* Removing the handset from the
cradle during an incoming call
automatically answers the call and
places the handset in TALK Mode.
* Placing the handset in the cradle
or pressing END will end a call.
Station not
registered
~ 20~
*
*
*
*
*
From the IDLE mode, enter the number
you wish to call. The number you input
will appear on the handset screen as
typed. For example, the number
555-1221 would appear as:
If an incorrect number has been entered,
select the CLEAR option by pressing the
RIGHT SOFT FUNCTION key to clear the
entire number, then re-enter the number
you wish
The DELETE option is selected by
pressing the LEFT SOFT FUNCTION
key. DELETE will delete one digit
at a time from right to left, similar
to a backspace key
When the correct number is displayed
on the screen, press TALK to complete
the call
You will hear a dial tone and see the
following three screens as the number is
dialed:
Making Calls
You can enter a phone number before or after connecting to dial
tone. An available line is automatically located by the handset, but
to select a particular line intercom the base for the line first, press
END, then dial.
Selecting a phone number before connecting to dial tone offers
the advantage of reaching the correct party with the first phone
call.If a pause is required (PABX ext) use ** to insert a pause.
One of the following three methods may be used:
Manual Dial(Pre-Dial Tone)
ENTERING A NUMBER BEFORE CONNECTING TO
DIAL TONE
5551221_
DELETE CLEAR
Connecting to
base 1 Line
Dialing
5551221
00:00:08
Volume: 5
HOLD
MUTE
Incoming Call
On Base 1
SILENT