Enviro C-11089 - Manual (Page 38)

Trouble Shooting
Problem Possible Cause Solution
3 short beeps while
motor turns.
One or more of the
batteries are low.
• Replace the batteries, refer to M
AINTENANCE
A
ND
S
ERVICE
- R
EPLACING
T
HE
B
ATTERIES
.
W ARNING : Creating an electrical short between
the batteries/battery box and metal parts of the
appliance may render the receiver inoperable.
Pilot flame lights but
there is no main gas
flow.
Valve turned down to pilot
flow.
• Turn flame to high fire by pressing the up button
on the remote handset
Low inlet pressure. • Confirm the regulator’s pressure and sizing.
Replace valve if necessary.
Valve. • Replace the valve.
Flame lifting Leak in vent pipe. • Check for leaks in vent connections.
Improper vent
configuration.
• Check vent configuration with manual.
Terminal may be
recirculating flue gases.
• Check to see if terminal is on correctly.
• May need to install high wind termination cap.
• Contact dealer.
Glass fogs up Normal Condition: after the appliance warms up the glass will clear.
**Due to additives in gas, glass may get hazy during operation** Clean as
needed.
Blue Flames Normal during start up: flames will yellow as the fireplace heats up.
Flames are burning
“dirty” or sooting
Flame impingement • Check log positioning.
• Increase primary air by opening the venturi
shutter and/or by opening the vent restrictor.
See also “Burners will not remain lit.”
BV ONLY:
Insufficient air for
combustion
• Air tight house.
• A vacuum in room due to
other air-moving device.
• Supply make up air to the unit.
38
Parts List - Components
Reference
Number
Part Description Part Number
1 120°F (49°C) Ceramic Fan Temperature Sensor EC-001
2 FPI Burner Switch EC-026
3 Domestic Power Cord (115V) EC-042
4 Heyco Strain Relief EC-044
5 Embers (Coal & Wool) EC-046
6 Convection Blower 115V EG22-001
12 oz. Can of Flat Black Touch Up Paint PAINT-12-FB
7 Blank Orifice 50-343
8 Dual Bulb Door Gasket (10ft) 50-634