Enterasys Networks Enterasys Vertical Horizon VH-8G - Manual (Page 37)

9033639 Technical Specifications 23
Port Specifications
Console Port
Table A-1 shows the console port pin assignments.
Table A-1. RS-232 Console Port Pin Assignments
Power Cord Set Requirements
The wide-range input feature of the VH-8G Gigabit Ethernet switch
permits it to operate from any line voltage between 100 and 240 VAC.
The power cord set (appliance coupler, flexible cord, and wall plug) you
received with the switch meets the requirements for use in the country
where you purchased the switch.
Power cord sets for use in other countries must meet the requirements of
the country where you use the switch. For more information on power
cord set requirements, contact your Enterasys Networks Support
Representative.
General Requirements
The requirements listed below are applicable to all countries:
• The length of the power cord set must be at least 5.00 feet (1.5 m)
and a maximum of 6.56 feet (2.0 m).
• All power cord sets must be approved by an acceptable accredited
agency responsible for evaluation in the country where the power
cord set will be used.
Pin Signal Name
1 DCD
2 RXD
3 TXD
4 DTR
5 Ground
6 DSR
7 RTS
8 CTS
9 RI
VH-8g.book Page 23 Friday, November 17, 2000 5:29 PM