Enterasys Networks Enterasys Vertical Horizon VH-8G - Manual (Page 31)

9033639 Installation 17
5. Configure the terminal to the following communication settings:
VT100 emulation, 19200 baud, no parity, 8 data bits, 1 stop bit, no
flow control, ASCII character set.
In-Band Connections
Prior to accessing the switch via a network connection, you must
configure it with a valid IP address, subnet mask, and default gateway
using an out-of-band connection or the BootP protocol.
Telnet Connection - Prior to accessing the switch via an in-band Telnet
connection, you must configure it with a valid IP address, subnet mask,
and default gateway using an out-of-band connection or the BootP
protocol. After configuring the switch’s IP parameters, you can access the
on-board configuration program from anywhere within the attached
network .
In-Band Network Connection - The on-board configuration program can
be accessed using Telnet from any computer attached to the network.
The switch can also be managed by any computer using a web browser
(Internet Explorer 4.0 or above, or Netscape Navigator 4.0 or above), or
from a network computer using third-party network management
software.
The switch must first be configured to issue BootP
requests, since the default is BootP disabled. Refer to
the Management Guide for more information.
VH-8g.book Page 17 Friday, November 17, 2000 5:29 PM