beautypg.com

Adjust the projected image with the setup guide, Select the input mode, Turn the computer on – Eiki EIP-250 User Manual

Page 19

background image

17

4. Adjust the projected image with the Setup Guide

_PP. 26, 27

1

After the projector turns on, the Setup Guide appears.
(When “Setup Guide” is set to “On”. See page

44

.)

2

Follow the steps in the Setup Guide and adjust the focus, height (angle) and picture size.

3

After adjusting the focus, height (angle) and picture size, press ENTER to finish the Setup
Guide.

Correcting trapezoidal distortion using Keystone Correction.

5. Correct trapezoidal distortion

8. Turn the power off

Press STANDBY/ON on the projector or STANDBY on the remote control, and then press the
button again while the confirmation message is displayed to put the projector into standby mode.

On-screen display

On the

projector

On the remote

control

_P. 25

On the projector

On the remote control

Shrinks

upper side.

Shrinks

lower side.

_P. 28

Select the “COMPUTER” using INPUT on the projector or COMPUTER on the remote control.

6. Select the INPUT mode

• When you press INPUT on the projector, the INPUT list appears.

Press '/" to switch the INPUT mode.

On the

projector

On the remote

control

INPUT list

_P. 29

On-screen display (RGB)

RGB
1024 × 768

COMPUTER

7. Turn the computer on

INPUT

COMPUTER

DVI-D Computer

*

*

EIP-2600 only

D

DVI-D Video

D