GE 600 Series 30 Inch Slide-In Gas Smart Range Owners Guide - Manual (Page 32)

32
49-2001193 Rev. 0
Troubleshooting Tips ... Before you call for service
TROUBLESHOOTING TIPS
Problem Possible Cause What To Do
“F— and a number or
letter” apear or flash in
the display You have a function error code. Press the Cancel pad. Allow the oven to cool and then put
the oven back into operation.
If the function code repeats. Press the Cancel pad.
Disconnect all power to the oven for at least 30 seconds
and then reconnect power. If the function error code
repeats again, call for service.
Oven will not work
remotely Router issues, no wireless signal, etc. Check with your internet provider or your wireless router
to ensure there are no issues.
Your oven is not connected to your new router but is
still connected to your old router. Disconnect your oven and reconnect to the new router.
See the Connecting to Wi-Fi section to reconnect your
oven.
Oven is not connected. See the Connecting to Wi-Fi section.
Wi-Fi board is off. Turn the Wi-Fi board on. See the Settings section.
Remote enable is off. Turn remote enable on. See the Settings section.
My oven door glass
appears to be "tinted" or
have a "rainbow" color. The inner oven glass is coated with a heat barrier to
reflect the heat back into the oven to prevent heat
loss and keep the outer door cool while baking. 7KLVLVQRUPDO8QGHUFHUWDLQOLJKWRUDQJOHV\RXPD\VHH
this tint or rainbow color.
Oven door is crooked The door is out of position. Because the oven door is removable, it sometimes gets
out of position during installation. To straighten the door,
re-install the door. See the Care and Cleaning – Exterior
Surfaces – Oven Door section.
Drawer does not slide
smoothly or drags The drawer is out of alignment Fully extend the drawer and push it all the way in See the
Care and Cleaning – Exterior Surfaces – Storage Drawer
section.
Drawer is over-loaded or load is unbalanced. Reduce weight. Redistribute drawer contents.
Storage drawer won’t
close Rear drawer support is on top of the guide rail. Reposition the drawer. See the See the Care and
Cleaning – Exterior Surfaces – Storage Drawer section.
Surface units will not
maintain a rolling boil
or cooking is not fast
enough Burner size is too small for the cookware The flame size on a burner should match the size of the
cookware being used. See the Gas Cooktop - Selecting a
Flame Size section
Flame size is too large for the cookware The flame size on a burner should match the size of the
cookware being used. Flames larger than the bottom of
the cookower may be hazardous. See the Gas Cooktop -
Selecting a Flame Size section
In some areas the heating value of the gas may be
low Cover pan with a lid until desired heat is obtained.