LG Studio 30 Inch Slide-In Gas Smart Range Owners Manual User Manual
Page 25
25
OPERATION
EN
G
LIS
H
• enable/disable convection auto conversion
• adjust the oven temperature
• activate/deactivate the preheating alarm light
• set the beeper volume
• switch the temperature scale between
Fahrenheit and Celsius
Setting the Hour Mode
The control is set to use a 12-hour clock. To reset
the clock to 24-hour mode, follow the steps below.
1
Press
Settings
once.
2
Press
1
to toggle between a 12-hour and 24-
hour clock.
3
Press
START
to accept the change.
Setting Convection Auto Conversion
When
Conv. Bake
and
Conv. Roast
are selected,
Convection Auto Conversion automatically
converts the standard recipe temperature entered
to a convection temperature by subtracting 25
ૢ
/
14
. This auto converted temperature shows on
the display. For example, select
Conv. Bake
, enter
350
ૢ
, and 325
ૢ
shows on the display after
preheat.
Convection Auto Conversion is enabled by default.
To change the setting, follow these instructions.
1
Press
Settings
repeatedly until
Auto
appears
in the display.
2
Press
1
to disable or enable auto conversion.
3
Press
START
to accept the change.
Adjusting the Oven Thermostat
Your new oven may cook differently from the one
it replaced. Use your new oven for a few weeks to
become more familiar with it before changing the
temperature settings. If after familiarizing yourself
with the new oven, you still think that it is too hot
or too cold, you can adjust the oven thermostat
yourself.
• To begin, either raise or lower the thermostat
15
ૢ
(8
). Try the oven with the new setting. If
the oven still needs adjustment, raise or lower
the thermostat again, using the first adjustment
as a gauge. For example, if the adjustment was
too much, raise or lower the thermostat 10
ૢ
(5
). If the adjustment was not enough, raise or
lower the thermostat 20
ૢ
(12
). Proceed in
this way until the oven is adjusted to your
satisfaction.
1
Press
Settings
repeatedly until
AdJU
appears
in the display.
2
Use the number buttons to enter the number
of degrees you want to adjust the oven
temperature.
3
Adjust the temperature either up or down by
pressing
Settings
repeatedly to toggle
between plus (+) or minus (-).
4
Press
START
to accept the change.
NOTE
• This adjustment does not affect the broiling or
Self Clean temperatures. The adjustment is
retained in memory after a power failure. The
oven temperature can be increased (+) or
decreased (-) as much as 35
ૢ
or 19
.
• Once the temperature is increased or decreased,
the display shows the adjusted temperature
until it readjusts.
Turning the Preheat Alarm Light On/Off
When the oven reaches its set-temperature, the
preheating alarm light flashes 5 times or until the
oven door is opened.
You can activate or deactivate the preheating
alarm light.
1
Press
Settings
repeatedly until
PrE
appears in
the display.
2
Press
1
to turn the light on/off.
3
Press
START
to accept the change.
Adjusting the Beeper Volume
1
Press
Settings
repeatedly until
Beep
appears
in the display.
2
Press
1
to select
Hi
,
Lo
or
Off
.
3
Press
START
to accept the change.
UUGGwGY\GG{ SGhGY[SGYWYXGG[aXXGwt