beautypg.com

Maintenance – Samsung 30 Inch Slide-in Gas Smart Range Owner Manual User Manual

Page 50

background image

50 English

Maint

enanc

e

Maintenance

To perform the self-cleaning cycle

Make sure the door lock is released. Remove all racks from the oven cavity.

1.

Make sure the oven door is closed completely and unlocked.

2.

Tap

, and select

Self Clean

using the dial knob. Then, select the cleaning time

by turning the dial knob one or more times in accordance with the table below.

Left turn

Default

Right turn

2-hour cycle

3-hour cycle

5-hour cycle

3.

Tap

START

. The oven door is locked and the oven begins to heat up.

4.

When the self-cleaning cycle is complete, the oven beeps. The door will remain
locked until the oven temperature falls below 400 °F (200 °C). You can open the
door when it is safe to open.

CAUTION

Do not use the surface burners while the gas oven is performing a self-cleaning
cycle.

WARNING

Be sure all controls are OFF and all surfaces are COOL before cleaning any part of
the range.

NOTE

Make sure all surface burners are off while
the oven is performing a self cleaning
cycle. Self-clean will not operate if a surface
burner is on.

To delay starting a self-cleaning cycle

1.

Repeat steps 1 and 2 on the previous page.

2.

Select

Set Delay Start

.

3.

Set the time you want the oven to start self-cleaning using the dial knob.

4.

Tap

START

. The oven will start self-cleaning at your specified time.

To cancel the self-cleaning cycle

You may find it necessary to stop or interrupt a self-cleaning cycle due to smoke in
the oven. To turn off the self-cleaning cycle, tap

OFF

. The cycle turns off, but the door

remains locked and the Lock icon blinks until the oven temperature falls below 400 °F
(200 °C).

After self-cleaning

The door stays locked until the internal oven temperature falls below 400 °F.

When the oven has cooled down, wipe the oven surfaces with a cloth to remove ash residue.

Stubborn stains can be removed using a steel-wool pad. Lime deposits can be
removed using a vinegar-soaking cloth.

If you are not satisfied with the cleaning results, repeat the cycle. Wait until the oven
cools down and then start a new cycle.

The cooling fan automatically runs for certain amount of time after self-cleaning.

Self-cleaning does not operate within 2 hours after running the self-cleaning cycle.

CAUTION

Do not attempt to open the oven door immediately after the self-cleaning cycle is
complete. The oven is still very hot when the door unlocks. Escaping hot air and/or
steam could burn you.

NX60T8751SS_AA_DG68-01219A-00_EN.indd 50

3/26/2020 8:39:45 PM

This manual is related to the following products: