Maintenance, Cleaning, Cleaning 43 – Samsung 30 Inch Slide-in Gas Smart Range Owner Manual User Manual
Page 43
English 43
Maint
enanc
e
Oven remote control using the SmartThings app
Error Check
•
Automatically recognize errors.
Temp Probe
•
Monitor the current temperature and reset the
probe setting.
•
If is not shown in the display, you are still able to monitor the oven and
cooktop status and turn the oven off.
WI-FI On/Off
If you turn WI-FI mode Off, mobile devices cannot connect to the range.
1.
Tap and hold
for 3 sec.
2.
Select
Wi-Fi
using the dial knob.
3.
Turn the dial knob to select
On/Off
and push to save the changes.
NOTE
•
Opening the oven door or tapping
Smart Control
will delete from the display
and prevent most of the remote functions from operating.
•
When oven cooking is finished or cancelled, is removed from the display.
•
For safety reasons, you cannot turn on the gas oven remotely.
•
For safety reasons, you must specify the cooking time to enable remote control.
•
The oven continues operating even if the Wi-Fi connection is lost.
•
Smart Control
will not work properly if the Wi-Fi Connection is unstable.
•
See the SmartThings app manual for detailed information.
Maintenance
Cleaning
Control panel
First, lock the control panel and the door to prevent accidental operations and/or
product tipping.
1.
Tap
, and select
Lock
using the dial knob to lock both the control panel and
the door.
2.
Clean the control panel using a soft cloth dampened with plain water, warm
soapy water, or glass cleaner. Do not spray cleansers directly onto the control
panel.
3.
When done, touch
, and select
Lock
using the dial knob to unlock both the
control panel and the door.
WARNING
•
Make sure the control panel turns off and all surfaces of the range are cool
before cleaning. Otherwise, you can get burned.
•
If the range has been moved away from the wall, make sure the Anti-Tip device
is reinstalled properly when the range has been put into place again. Otherwise,
the range may tip over, causing physical injuries.
•
Do not use steel-wool or abrasive cleansers of any kind. These can scratch or
damage the surface.
Stainless steel surface
1.
Remove any spills, spots, and grease stains using a soft, wet cloth.
2.
Apply an approved stainless steel cleanser to a cloth or paper towel.
3.
Clean one small area at a time, rubbing with the grain of the stainless steel if
applicable.
4.
When done, dry the surface using a soft, dry cloth.
5.
Repeat steps 2 through 4 as many times as necessary.
CAUTION
•
Do not use a steel-wool pad or abrasive cleanser on stainless steel surfaces. It
will scratch the surface.
•
Do not spray any type of cleanser into the manifold holes. The ignition system is
located in those holes and must be kept free of moisture.
NX60T8751SS_AA_DG68-01219A-00_EN.indd 43
3/26/2020 8:39:40 PM