Eiki EIP-S200 - Manual (Page 24)

EN-23
Image (Computer / Video Mode)
Contrast
The contrast controls the degree of difference between the lightest and darkest parts
of the picture. Adjusting the contrast changes the amount of black and white in the
image.
Q
Press W to decrease the contrast.
Q
Press X to increase the contrast.
Brightness
Adjusts brightness of the image.
Q
Press W to darken the image.
Q
Press X to lighten the image.
Keystone
Adjusts image distortion caused by tilting the projector.
Aspect Ratio
Use this function to choose your desired image size.
Q
1 :1: Keep the image with original width-height ratio and maximize the image to fit
native horizontal or vertical pixels.
Q
16:9: The input source will be scaled to fit the width of the screen.
Q
4:3: The input source will be scaled to fit the projection screen.
Blank Screen
Blanks the screen temporarily, and selects the screen color when this function is active.
Q
Black / Blue / Gray / Red / Green / Yellow / Cyan / Magenta / White
Gamma
Selects Gamma mode.
Q
RGB: Computer text mode
Q
Photographic: Computer photo mode
Q
Video: Common video mode
Q
Film: Dark video image mode
White Peaking
The white peaking control adjusts the white peaking level of the DMD chip. 0 stands for
minimal segment, and 10 stands for maximum segment. If you prefer a stronger image,
adjust towards the maximum setting. For a smooth and more natural image, adjust
towards the minimum setting.
Color Temperature
Adjusts color temperature. At higher temperature, the screen looks colder; at lower
temperature, the screen looks warmer. If you select “User”, “Red”, “Green” and “Blue”
can be adjusted.