Electrolux 76669 - Manual (Page 44)

Installation and connection instructions
44
3 The special spanner A and the
caps B (2 each) and C (1 each)
are supplied with it.
3. Remove the screw D, including
the compression spring with the
special spanner A.
4. Cover the hole with the cap C.
Important! When fitting the
plastic caps, press until they snap
into the rear panel securely.
5. Remove the two screws E with
the special spanner A.
6. Remove the 4 screws F.
7. Remove the transit bar G.
8. Screw the 4 screws F back in for
safe keeping.
9. Close the 2 large holes with the
caps B.
Important! When fitting the
plastic caps, press until they snap
into the rear panel securely.
Installation-Site preparation
• The installation surface must be clean, dry and level. Do not install on
a deep pile carpet.
• Minor unevenness of the floor surface should never be levelled out by
laying pieces of wood, card or similar materials, but should always be
compensated for by adjusting the screw feet.
• If the appliance is installed next to a heat source (e.g. cooking appli-
ance), a heat insulating pad (87 x 57 cm) must be placed between the
appliance and the heat source.
• Do not install the appliance in locations where the temperature may
fall below freezing.
• Please ensure that when the appliance is installed it is easily accessi-
ble for the engineer in the event of a breakdown.