Epson Endeavor WG - Manual (Page 45)

Note
You cannot change or delete your network server mode
password as you enter it to access your computer. You must
run SETUP to change or delete it. See Chapter 2 of the
Setup Guide for instructions.
Changing the Processor Speed
Your computer’s processor can operate at two speeds: high
or low. High speed is the highest speed at which your
microprocessor is capable of running, such as 33 or 50 MHz.
Low speed simulates an 8 MHz processor to provide
compatibility with older application programs.
You can also set the computer to automatic speed, which
switches your computer’s processor from high to low speed
when it accesses a diskette drive.
.
When your computer is operating at high speed, the SPEED
on the front panel green. When the computer is
operating at low speed, the light is amber.
You should use high speed for almost everything you do
because your programs will work faster. However, certain
application programs have specific timing requirements and
can run only at the slower speed. See your software manual to
determine if this is the case.
1-28 Using Your Computer