Dacor Contemporary 24 Inch Microwave Drawer Install Guide - Manual (Page 6)

E5
Design Specifications
ANTI-TIP BLOCK
NORMAL INSTALLATION STEPS
ANTI-TIP BLOCK INSTALLATION INSTRUCTIONS
To reduce the risk of tipping the drawer, the anti-tip
block must be properly installed 14 13 / 16
" above the floor
cutout. The 6" anti-tip block must be provided by the
installer. See Figures 2 and 6 for (24") or Figures 4, 5,
and 6 (for 30"). The anti-tip block prevents serious injury
that might result from spilled hot liquids.
If the drawer is moved to a different location later, the
anti-tip block must also be moved and installed. When
installed to the wall, make sure that the screws completely
VERIFYING PACKAGE
CONTENTS
• Remove all packing materials from inside the
drawer. DO NOT REMOVE THE WAVEGUIDE
COVER, which is located inside, on the ceiling of
the Microwave In-A-Drawer™.
Waveguide
Cover
Sealing
Surface
• Remove the feature sticker, if there is one. Check
the drawer for any damage, such as misaligned or
bent drawer, damaged drawer seals and sealing
surfaces, broken or loose drawer guides and
dents inside the cavity or on the front side of the
drawer. If there is any damage, do not install or
operate the Microwave In-A-Drawer™ and contact
your dealer or a DACOR AUTHORIZED SERVICER.
Sealing
Surface
Oven
Cavity
Figure 7
ELECTRICAL OUTLET
4"
5"
electrical outlet
location
anti-tip
block
(6")
Figure 8
The electrical requirements are a 120 volt 60 Hz, AC
only, 15 amp. or more protected electrical supply. It
is recommended that a separate circuit serving only
this appliance be provided.
The drawer is equipped with a 3-prong grounding
plug. It must be plugged into a wall receptacle that
is properly installed and grounded. Should you only
have a 2-prong outlet, have a qualified electrician
install a correct wall receptacle.
NOTE:
If you have any questions about the grounding or
electrical instructions, consult a qualified electrician
or service person.
penetrate the dry wall and are properly secured into the
base material underneath so that the block is totally
stable. When fastening, be sure that the screws do not
penetrate electrical wiring or plumbing.
4"
5"
electrical outlet
location
anti-tip
block
(6")
Figure 6
Installation Instructions