Dacor Contemporary 24 Inch Microwave Drawer Install Guide - Manual (Page 4)

E3
Design Specifications
A
B
C
D E
F
G
H
I
I J
K
L
M
N
0
P
A
B
C
L K
J
D
E
G
H
F
I
M
M
N
O
P
Q
R
A
B
C
F
I
D
H
G
E
J
A B
C
D E
F
G
H
I
I J
K
L
M
N
0
P
A
B
C
L K
J
D
E
G
H
F
I
M
M
N
O
P
Q
R
A
B
C
F
I
D
H
G
E
J
CLEARANCES AND
DIMENSIONS
• Dimensions that are shown in Figures 2, 4
and 5 must be used. Given dimensions provide
minimum clearance. Locate the electrical outlet
in the shaded area in the upper left-hand corner
of the cutout. See Figure 8.
• The contact surface must be solid and level.
Pay special attention to the floor on which the
drawer will sit. The floor of the opening should be
constructed of plywood strong enough to support
the weight of the unit (about 100 pounds).
• Check the location where the drawer will be
installed for proper electrical supply.
• Your oven can be built into a cabinet or wall by
itself or under any gas or electric wall oven.
• Be sure that the clearance of the floor between
the wall oven and the drawer is a minimum of 2".
• The Microwave In-A-Drawer™ interior will easily
accommodate a 9” x 13” oblong dish or bag of
microwave popcorn.
• The Microwave In-A-Drawer™ can also be
mounted flush. Please see instructions for flush
mounting included with the flush mount deflector
vent.
24" DRAWER MEASUREMENTS
Figures 1 and 2 contain many Microwave In-A-Drawer™
measurements for reference when planning the drawer’s
location.
Figure 2
A. 6"
B. Electrical outlet location
C. Anti-tip block
D. 5"
E. 3 1 / 2 "
F. 4"
G. 22 1 / 8 " opening
H. 14 13 / 16 " to bottom
of anti-tip block
Figure 1
A. 21 5 / 8 "
B. 4 11 / 16 "
C. 1 3 / 4 "
D. 21 7 / 8 "
E. 23 7 / 8 "
F. 15 7 / 8 "
G. 14 19 / 32 "
H. 1 9 / 64 " door thickness
I. 15" auto drawer opening
J. 4"
I. Allow 7 / 8 " minimum overlap
J. 23 1 / 2 " minimum depth
K. Allow 3 / 16 " minimum overlap
L. 36" nominal countertop height
M. Allow 1 / 8 " minimum overlap
N. Floor must support 100 lbs.
O. *24" cabinet minimum
P. 15 9 / 16 " opening
NOTE: Open Top Cabinet illustrated