Enviro 828 DV.INS. - Manual (Page 8)

5. INSTALLING BURNER CONTROL ASSEMBLY
Remove the controls from box, check for shipping damage. Remove burner
tray from controls (one screw on each side between burners).
Open door. Remove grate rod by pulling up at each end. Remove the 2
screws behind the grate and one screw on each side of control opening in
firebox.
Extend flex gas line and place through hole in center of pedestal (freestanding
and inserts) or through hole in right or left firebox side (insert only). Lower the
controls into place at the back while pulling the flex line through on other side.
Lower front into place, the control knob may need to be pushed in to allow
burner controls to fit.
Install the two side screws, then install the front screws through the grate into
the firebox. Replace burner tray.
Install the grate rod and logset.
6. INSTALLATION OF LOG SET and EMBERS
Upon the first light up, watch for ignition to all burner
ports. If a long delay is noted:
a) First, wait for the appliance to cool down
b) Open the front door of the appliance.
c) Checks to Carefully reposition the embers making sure
that burner ports are not plugged solid or blocked
CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE
DOOR REMOVED
INSTALLING THE LOG
a. INSTALLING THE GLOWING EMBERS
Carefully remove log from unit. Check to ensure there is
no damage. It is very important to install this log in its
proper position to insure safe optimum operating
conditions.
A bag of ceramic fiber embers is provided for use on the
front burner ember tray.
CAUTION: Use only the type of ember material supplied
with this appliance. Due to the irregular size of the ember
material there may be more than required. Use only a
single layer. Do not pile embers. The use of other foreign
materials on the burners may create dangerous
conditions.
If over time, through cleaning and servicing, these embers
require replacement, contact your nearest ENVIROGAS
dealer for replacement embers.
Gently remove the ember material from the plastic bag.
Spreading these pieces evenly across the front of the
ember tray. Place a single layer of embers on top of the
front burner. Carefully avoid any clumping or large build-
ups.
Do not pack down, leave embers loose. 1. Open the front door.
DO NOT PLACE EMBERS ON THE REAR BURNER.
8