Enviro 828 DV.INS. - Manual (Page 7)

FIREPLACE INSERT
•
Carefully clean the fireplace and flue before installing the stove. Failure to do so may result in fumes or dirt being blown into
the room or insert and may cause a fire leading to death or serious injury.
•
If you are installing the optional fan kit, (see Installing Fan Kit) do so now.
•
If the fireplace has a dropped or uneven bottom, install the optional rear leveling legs. The leg brackets attach into the side rear
of the firebox with the torx screws provided. Thread the 5” bolt into the retaining nut. Install the lock nuts.
• Install front and rear mounting rails using the screws provided (See
figure 4). Mount the 3” vent coupling to the unit, making sure you have
compressed the larger round gasket.
Back Rail
Securely fasten (with a clamp or screws) the vent adapter box to the
flexible 3” vent pipe liners previously installed in the chimney. Be
careful not to over stretch the liners. Caution: do not mix up the
intake with the exhaust pipe.
•
Place the unit part way into the fireplace opening. Connect the insert's
flexible gas line to the household gas supply using locally approved
methods.
•
For units with optional fan, place the power cord so it can be connected
to the power supply.
•
Push the unit into its final position in the fireplace. Adjust the leveling
legs and tighten the lock nuts, insuring that the appliance is stable and
level.
•
Push the insert adapter box under the rear rail then push down on the
front of the box. Install the screw to secure.
•
Remove the screws holding the hinged side flaps to the panel
mounting brackets on each side of the unit (fig 5).
Insert Adapter Box
3” Vent Coupling
Front Rail
•
Loosen the 1/4" nuts (7/16" wrench) holding the stove top to
the unit. Pull the top forward, lift up and remove.
•
Attach the surround panels together on the floor, using the
two 1/4” nuts and bolts provided per side.
•
For units with optional fan, connect fan wire harness to the
blower wires following the wiring diagram.
•
Place the assembled surround panel around the stove, in
front of the surround mounting brackets. Make sure the top
panel sits flat on the stove and the mounting holes on the
side, line up.
•
Re-attach the hinged side flaps, screwing through the
surround panel into the brackets. Re-install the top and
secure.
7