Enviro 828 DV.INS. - Manual (Page 6)

3. DECIDING WHERE TO LOCATE YOUR STOVE
FREESTANDING:
• Locate the stove in a large and open room that is
centrally located in the house. This will optimize heat
circulation and comfort.
• The stove should be located out of traffic, away from
furniture and draperies and should have sufficient
access for its safe operation and maintenance.
• The flow of convection air can not be blocked
• The stove can be installed on any combustible flat
surface providing that it is installed on a metal or wood
panel extending the full width and depth of the
appliance.
• Check the stove and flue system clearance
requirements. Locate a position where the flue system
of the stove can be properly installed without damaging
the integrity of the building. e.g. cutting through a wall or
ceiling joist.
• Locate the stove where it can be accessed by a gas
supply line.
•
Note: If the stove is equipped with the optional
convection fan, the electrical cord is only 8 ft. (2.4 m)
long.
FIREPLACE INSERT
• The fireplace insert model can only be located in an existing wood burning steel or masonry fireplace. The existing chimney
must be lined using a Simpson Dura Vent sealed co-linear vent system using the Envirogas kit 828-135 (DV insert / co-linear
adapter).
4. ASSEMBLY INSTRUCTIONS
INSTALLATION
Remove the packaging from the appliance, pedestal or surround panels and burner controls, check to make sure there is no
damage. Carefully check the glass door. Do not use the unit if it is damaged. In the event damage is found, please report it to
both the courier and your dealer as soon as possible.
•
Open the two hinged side panels, open the door by undoing the bolt, located on the right side (1/2 inch wrench).
•
Remove the log and ember set from the firebox.
•
Remove the two hold down clamps that attach the stove to its pallet ( #2 Robertson screwdriver ). These are hooked through
the square openings immediately behind the side panels on each side of the unit.
BOTTOM VIEW
FREESTANDING
•
Place the stove on its back, on the pallet.
•
Back off the 4 screws ( 5/16 hex head located on the base) 2 turns. Place the
pedestal so that the screws in the base of the stove engage the keyholes in the
pedestal. Check to see that all screws are locked, then tighten with a 5/16 socket
wrench.
• Return unit to upright position. Complete the installation. Install the burner
controls, log set, embers and optional fan kit as per the instructions in the upcoming
sections.
PEDESTAL MOUNTING SCREWS
6