Enviro 828 DV.INS. - Manual (Page 21)

13. MAINTENANCE AND TECHNICAL
Periodically check to ensure that your "Direct Vent" system is
clear.
Periodically check the pilot and burner. Check to see that all
the burner ports are clean and clear. Check the pilot head
for blockage. Check to ensure the pilot flame is blue with
small yellow tips.
OPENING THE DOOR
Caution door is hot when in operation.
1. Open the right hand hinged side flap, which will
expose a door fastener. Using a 1/2" wrench, loosen
the fastener.
2. Due to the shape of the bay window door. You must
also open the left-hand side flap before attempting to
open the door.
CLEANING OF GLASS
Do not clean glass when hot
It will be necessary to clean the ceramic glass
periodically. During a cold start up, condensation will
sometimes form on the glass, this is a normal condition
with all gas fireplaces and stoves. However, this
condensation can allow dust and lint to cling to the
glass surface. Initial paint curing of the appliance can
leave behind a slight film on the glass. This is a
temporary problem. It is therefore recommended that
the glass be cleaned initially after about the first two
weeks of use.
After that, depending upon the amount of use, cleaning
should be required no more than two or three times per
season.
To clean the door, use a mild glass cleaner and a soft
cloth. Abrasive cleaners will damage the glass and
gold surfaces. Close door tightly.
TO REPLACE DOOR AND GLASS ASSEMBLY
The glass in this appliance is an integral part of the
door assembly. If the glass is damaged or broken a
replacement door assembly including glass must be
fitted.
To Replace:
• open door fully
• Lift door vertically so that hinge pins lift out of hinge
receivers.
• Return the door assembly to dealer.
Your ENVIROGAS Dealer must replace door and
glass assembly as a complete unit.
No substitute materials are allowed.
FOR CLEANING THE INSIDE OF THE FIREBOX
Remove the log carefully from the firebox. Gently
remove the embers and place on a piece of paper
towel, until ready to replace.
Vacuum the firebox thoroughly. Carefully clean off any
dust on the logs and remove any lint from the main
burner and pilot burner.
After carefully replacing the log and embers in their
correct positions, and the door has been resealed, re-
light the pilot, following the instructions on the attached
label.
CLEARANCES MUST BE SUFFICIENT TO ALLOW
ACCESS FOR MAINTENANCE AND SERVICE
LUBRICATING THE BLOWER
If installed, the blower should be lubricated every 6
months
1. Turn the unit off and remove the log set.
2. Remove the burner tray assembly by removing
the screw on either side of the tray, between the
front and rear burners. Lift tray out.
3. Remove the 8 screws that hold the blower
mounting plate to the back firewall. Use a light
lubricating oil on screws before removal.
4. Carefully pull the blower assembly into the
firebox, exposing the blower lubricating holes
(located on the top of the motor housing on either
side of the label). Add 2 drops of SAE 20 oil.
5. If removal of the blower is necessary, disconnect
the blower leads from the harness. Remove the
blower.
6. To re-install, check mounting plate gasket and
reverse steps 1 through 4.
21